Transition, Offset

Create a transition fitting or an offset between two ducts.

Ribbon group
Connect and Align
Version
PluBIM 1.5.0

Transition and Offset connect two ducts with a matching fitting. Both are on the PB-Modeling tab in the Connect and Align group, stacked with DuctTap.

You want to … How
Connect two ducts with different cross-sections Create a transition
Connect two parallel ducts that are offset from each other Create an offset

Which elements?

Works with Ducts, duct fittings and accessories, and mechanical and electrical equipment with an open duct connector
Not for Pipes, conduits, cable trays; elements without a connector
Creates a transition fitting or an offset from the families installed with PluBIM

Create a transition

Animation: Transition
Fig. 1 · Animation: two ducts with different cross-sections, connected with a transition
  1. In the ribbon, click PB-Modeling › Connect and Align › Transition.

  2. “Pick the face of the first element”: click the end face at the open end of the first duct.

  3. “Pick the face of the second element”: click the end face at the open end of the second duct.

A transition fitting sits between the ducts and is connected to both.

Create an offset

Animation: Offset
Fig. 2 · Animation: two parallel ducts offset from each other, connected with an offset
  1. In the ribbon, click PB-Modeling › Connect and Align › Offset.

  2. Click the end face at the open end of the first duct, then that of the second.

An offset sits between the ducts and is connected to both.

After creating it, PluBIM checks the offset's FitMatchKey. If it is 0, “Check the fitting” appears: check the fitting's diameter and make sure the angle is not larger than 45°.

Common problems

“Could not create the offset”: “Revit could not create the offset geometry …”

The distance between the ducts is too short for the offset. The message gives both values. Increase the distance and try again.

“Face not usable”: “You can not pick this face.”

Click the end face at the open duct end, not the side face.

“No connector”: “Element has no connectors, …”

The element has no duct connector. Choose another element.

“You can not use this command in this view, …”

Switch to another view type, for example a 3D view.

“Families folder missing” / “Family missing”

The families for Transition and Offset are installed with PluBIM and are missing on this computer. Reinstall PluBIM; if that does not help, contact support.

Related guides